Winter cutting the ribbon

Dear friends!

The foreman went on vacation and now I'm replacing him. There is a ribbon “Dobrynya Nikitich”, tape take on it HH,h the bimetal. Sawing pine needles pine spruce. The forest is frozen, so the volume has fallen sharply, the quality is also. Here and there was a few questions, to somehow raise the quality and productivity: What we need for the winter to do the divorce? What should be a cavity between teeth? What else to look for?

Thank you in advance!
Translated by «Yandex.Translator»

1. in the absence of the debarker in the winter time are sure to make a debarked sawn timber. 2. feed rate reduction at peripheral areas . 3. basically follow current recommendations on the use of bimetallic saws. 4. after -25 degrees divorce every third sharpening with a slight decrease in the degree of divorce by trial. 5. in the cavity of the tooth, it is desirable to produce light with a notch of the chisel , to have been destroyed the resulting mixture of sawdust and frozen water . 6.recommended condition : the thickness of the saw blade should be 1/ 1000 of the diameter of the pulley . I teased in these parameters to -31 with good quality ( pine ) 1 hour -1 hour 20 minutes - up to 1.5 cubic meters . roundwood . Please , always answer
Translated by «Yandex.Translator»